Snojax: Snow Guards

VentSaver HD

These installation guidelines are provided as assistance to installers with commercial and residential sites to install a VentSaver HD in four easy steps. SnoBlox - Snojax takes no responsibility for errors or omissions, and cannot be held responsible for product installation.

Step 1: Assemble Fin and Base Angle

Attach fin to base angle with two 1/4" X 3/4" S.S. bolts. In case of rib obstruction, base angle is reversible.

Step 2: Mount Base

Put sealant on bottom of base angle. Place cable over chimney or vent with VentSaver centered behind and close to pipe. Fasten base to roof with the four 1 1/2" lag screws. If unable to fit the cable over the top of the pipe, detach the cable eye by removing the nut. Wrap the cable around the pipe and reassemble tightly.

Step 3: Pull Cable

Pull on cable end with pliers until snug. Keep shoulder strap on the opposite side of the pipe from the VentSaver. Tighten nut and bolt firmly. Trim Excess cable. For smaller applications, cut and remove stainless steel shoulder strap attached to cable.

Step 4: Diverter Wing Kit

Install Snow Diverter Kit using the provided spacers, where necessary, to compensate for minor rib height.

Note:

*Note: There is a minimum of 16" of flat area required between the major ribs, centered behind the pipe, to use the snow diverter wing kit. Wing kit spacers are provided to straddle minor ribs, if present in the panel. The use if the wing kit is oprional and is not required.